Issue 1 January 2008
153
WFVQ (Weighted Fair VoIP Queuing)
Bind an object tracker to the interface to check
whether it is up
Set the speed for the interface
Configure traffic shaping for outbound traffic on
the current interface
Table 107: WAN Ethernet port configuration CLI commands (continued)
Root level command
First level command
Description
2 of 2
Table 108: WFVQ configuration CLI commands
Root level command
Command
Description
interface {serial|
FastEthernet|
dialer}
Enter interface configuration mode for either a
Serial, FastEthernet, or Dialer interface
Set the maximum number of packets that can be
queued in the weighted fair queue
Enable Weighted Fair VoIP Queuing (WFVQ) on
the current interface
Enable or disable priority queuing mode in a
Serial or FastEthernet interface. If you disable
priority queuing, WFVQ is re-enabled.
Display information about the real-time status of
output queues for the current interface
Enable or disable custom queueing for VoIP
traffic. If you disable custom queueing, WFVQ is
re-enabled.
Display the priority queue size, in packets
Summary of Contents for G450 Manager
