Object tracking
Issue 1 January 2008
601
source-address
Use the
source-address
command to set the source IP address for an RTR operation. Use
the
no
form of this command to restore the default setting, which is to use the output interface’s
IP address.
Note:
Note:
You must run the
type
command to define the RTR operation’s probing method
and the IP address of the remote device before you can use the
source-address
command.
Note:
Note:
By default, the
source-address
command is disabled, and RTR operations
use the output interface’s address.
Syntax
[no] source-address
ip-address
Parameters
User Level
read-write
Context
rtr, rtr type
Examples
To set the source IP address for RTR operations as IP address 135.64.102.5:
G450-001(config-rtr icmp 1)# source-address 135.64.102.5
Related Commands
,
,
Parameter
Description
Possible Values
Default Value
ip-address
The IP address to serve as the
source IP address for all RTR
operations
Summary of Contents for G450 Manager
