Object tracking
Issue 1 January 2008
603
wait-interval
Use the
wait-interval
command to specify how long an RTR operation should wait for a
device to answer an RTR probe. When the wait-interval is exceeded, the probe is considered an
unanswered probe.
Use the
no
form of this command to restore the value to the default.
Note:
Note:
You must run the
type
command to define the RTR operation’s probing method
and the IP address of the remote device before you can use the
wait-interval
command.
Note:
Note:
The value of
wait-interval
cannot be greater than the value of
frequency
.
Syntax
[no] wait-interval
wait-value
[seconds | milliseconds]
Parameters
User Level
read-write
Context
rtr, rtr type
Parameter
Description
Possible Values
Default Value
wait-value
A number indicating how
long to wait for a response
to the probe before
considering it an
unanswered probe
1-60
seconds
or
200-60,000
milliseconds
Same as
default value
of
frequency
seconds
Keyword indicating to set
the wait interval in units of
seconds
milliseconds
Keyword indicating to set
the wait interval in units of
milliseconds
Summary of Contents for G450 Manager
