CLI Commands
Policy - QoS lists
742 Avaya G450 CLI Reference
source-ip
Use the
source-ip
command to indicate that the current rule applies to packets from the
specified source IP address.
Use the
no
form of the command to indicate that the current rule applies to packets from any IP
address.
Use the
not
form of the command to indicate that the current rule applies to all packets
except
those coming from the specified IP address.
Syntax
[not] source-ip {host
ip_address
| any |
ip_address
wildcard
}
no source-ip
Parameters
User Level
read-write
Context
ip pbr-list ip-rule, ip qos-list ip-rule, ip capture-list ip-rule, ip access-control-list ip-rule, ip
crypto-list ip-rule
Note:
Note:
The
not
form of the command is not relevant in the crypto-list ip-rule context.
Parameter
Description
Possible
Values
Default
Value
host
Keyword that indicates a specific host IP
address
ip_address
The IP address of packets to which the rule
is applied
any
Keyword that indicates any IP address
ip_address
wildcard
The range of IP addresses of the rule.
The zero bits in the wildcard correspond to
bits in the IP address that remain fixed. The
one bits in the wildcard correspond to bits in
the IP address that can vary.
Note:
This is the opposite of how bits are
used in a netmask.
Summary of Contents for G450 Manager
