CLI Commands
PPPoE (PPP over Ethernet)
830 Avaya G450 CLI Reference
pppoe-client wait-for-ipcp
Use the
pppoe-client wait-for-ipcp
command to configure the amount of time
between PPPoE tunnel establishment and IPCP tunnel establishment. The PPPoE client
terminates the PPPoE tunnel if this time is exceeded. Use the
no
form of this command to
restore the default value, which is 20 seconds.
Note:
Note:
The PPP stack has a somewhat similar command:
ppp timeout ncp
.
However while this command only terminates the LCP, the
pppoe-client
wait-for-ipcp
command terminates the PPPoE tunnel.
Syntax
[no] pppoe-client wait-for-ipcp
seconds
Parameters
User Level
read-write
Context
interface:FastEthernet
Example
To configure the amount of time between PPPoE tunnel establishment and IPCP tunnel
establishment as 30 seconds:
G450-001(super-if:FastEthernet 10/2)# pppoe-client wait-for-ipcp 30
Related Commands
,
,
,
pppoe-client persistent max-attempts
Parameter
Description
Possible
Values
Default
Value
seconds
The number of seconds to wait
5-10000
20
Summary of Contents for G450 Manager
