Priority queueing
Issue 1 January 2008
831
Priority queueing
priority-queue
Use the
priority-queue
command to enable priority queueing mode in a Serial or
FastEthernet interface. By default, priority queueing is off, and WFVQ is enabled on all Serial
interfaces and all FastEthernet interfaces for which traffic-shaping is enabled. If you disable
priority queueing by using the
no
form of the
priority-queue
command, WFVQ is
re-enabled.
Syntax
[no] priority-queue
User Level
read-write
Context
interface:Serial (DS1 PPP L2-L3, DS1 PPP L2, USP PPP L2, USP PPP L2-L3), FastEthernet
(L2, L2-L3) - when Frame Relay Traffic Shaping is configured, Serial (DS1 FR L2, USP FR L2) -
when Frame Relay Traffic Shaping is not configured, Dialer (L2, L2-L3)
Example
To enable priority queueing:
G450-001(if:Serial 3/1:1)# priority-queue
Related Commands - Priority queueing
Related Commands - WFVQ
Summary of Contents for G450 Manager
