SLS survivability
Issue 1 January 2008
931
set interface
Use the
set interface
command to specify the glare-handling convention for a DS1 or BRI
link in SLS. This command also determines the polarity of the ISDN Layer 2 (LAPD) protocol
operation.
Note:
Note:
For a DS1 circuit, this command specifies the glare-handling convention for the
command that has been administered as
pbx
at the far-end of the
DS1 link.
Note:
Note:
This command is only valid for a DS1 or BRI circuit.
Syntax
set interface
glare-mode
Parameters
User Level
read-write
Context
>
>
Parameter
Description
Possible
Values
Default
Value
glare-mode
The glare-handling convention for a DS1 or BRI
link.
For non-QSIG calls:
●
network
– If the gateway is connected to a
host computer and encounters glare, it
overrides the far-end
●
user
– If the gateway is connected to a
public network and encounters glare, it
releases the circuit
For QSIG calls:
●
peerMaster
– SLS overrides the other end
when glare occurs
●
peerSlave
– SLS releases the circuit when
glare occurs
network
user
peerMaster
peerSlave
user
Summary of Contents for G450 Manager
