Upgrading an Existing S8300A to R2.2
280 Installation and Upgrades for Avaya G700 Media Gateway and Avaya S8300 Media Server
2. Enter the IP address where the Linux-Migration backup file is stored.
3. Click Execute Ping.
If the ping is successful, continue with restoring the system files. Otherwise, check the IP
address and connectivity to the server.
Restoring data
In this section you will restore the system data that you backed up. Do only one of the following
three procedures, depending on how you backed up the data:
●
Restoring data backup (if upgrading from a Pre-1.2 release)
on page 280
●
Restoring the Linux migration backup file (If upgrading from R1.2.x through R1.3.x)
on
page 282
●
Restoring data backup (If upgrading from R2.0.x)
on page 285
Note:
Note:
The backup and restore processes use the ping service to check connectivity to
the backup server. If a backup or restore operation fails, ensure that the ping
service is enabled:
i. On the Maintenance Web Interface, under Security, select Firewall.
ii. In the Service column, find ping.
iii. The checkboxes for both Input to Server and Output from Server should be
checked.
Restoring data backup
(if upgrading from a Pre-1.2 release)
Do these tasks only if you have upgraded from a pre-1.2 release.
To restore translations from a pre-1.2 release
1. Select View/Restore Data under Data Backup/Restore.
2. Select FTP and enter the information for the FTP backup server.
Click View.
3. Select the Communication Manager translations backup set to restore (filename begins with
"xln".
Click Restore.
