About installation and cabling
Issue 7 January 2005
93
Figure 12: Insert Media Module
4. Apply firm pressure to engage the connectors.
The media module connector has different length pins. The long pins will engage first to
provide grounding. Medium length and short pins will provide power and signal.
5. Lock the media module into the chassis by tightening the spring-loaded captive screws on
the front of the module.
!
WARNING:
WARNING:
To prevent access to electrical hazards by unauthorized personnel and to ensure
continued compliance to international radiated emissions requirements, all
captive screws must be securely tightened such that they cannot be loosened
without the use of a tool.
!
WARNING:
WARNING:
After you have connected telephones to the various media modules, be sure to
add circuit protection to the lines (see
Complete the telephone installation
process
on page 401).
At this point, you have readied the G700, inserted the S8300, if required, and inserted the
media modules, as described in the planning documentation. Next, if required, the Expansion
Module should be inserted into its bay.
