Setting up pre-installed software
Issue 1.0 September 2003 21
Setting up pre-installed software
Follow the information in this section only if you purchased a Avaya IR system that includes
the hardware platform with the IR software pre-installed. Configuring the pre-installed
software is usually performed by an Avaya service technician or certified third-party service
provider.
If you have purchased only the IR software from Avaya, see Installing system base software
from CD on page 31 for information on how to install the system on a separately acquired
hardware platform.
This section includes the following topics:
Preparing for configuring the pre-installed software........................ 21
Pre-installed software packages ..................................................... 22
Configuring the pre-installed software............................................. 23
Preparing for configuring the pre-
installed software
You must have a console connection to the platform on which you configuring the pre-
installed software. Each platform as the following minimum console requirements:
•
Sun Blade 150 must have one of the following:
―
ASCII terminal connected to the serial port
―
Keyboard and mouse connected to the USB ports and a monitor connected to the
VGA video connector
•
Sun Fire 280R must have an ASCII terminal connected to serial port A
The following site-specific information is required to respond to system prompts when you
start the system for the first time:
•
Default router IP address (if applicable)
•
Host name for the IR system
•
IP address for the IR system
•
Network mask (if part of a subnet)