Installing the system base software from CD
Issue 1.0 September 2003 37
Step System
prompt
Action
14
System part of a subnet
[ ] Yes
[ ] No
Select whether your system is part of a
subnet and press F2.
If you choose
Yes,
the system prompts you
for the subnet mask. In this case, enter the
subnet mask and press F2.
15
Netmask:
Enter the subnet mask and press F2.
16
Enable IPv6
[ ] Yes
[ ] No
Select
No
and press F2.
IMPORTANT:
IPv6 is not supported in this release.
After a short wait (approximately 30
seconds), the system displays the network
information you entered similar to the
following example:
17
Host name:
host
IP address: I
P address
System part of a subnet:
Yes
Netmask:
subnet mask
Enable IPv6:
No
Review the information to make sure it is
accurate and press
F2 to continue. If the
information is not correct, press F4 and
correct the information starting with the
Networked question.
18
Configuring default router
Enter default router IP address
(ex. 192.1.7.254) or 'none':
Enter the IP address of the default router (if
applicable).
The system verifies the default router. This
activity takes a few minutes to complete.
19
Configure Kerberos Security
[ ] Yes
[ ] No
Choose
No
and press F2.
IMPORTANT:
Kerberos Security is not supported in this
release.
20
Confirm the following
information. If it is correct,
press F2; to change any
information, press F4.
Configure Kerberos Security: No
Press F2 to confirm.
21
Name service
[ ] NIS+
[ ] NIS
[ ] DNS
[ ] LDAP
[ ] None
Select your name service and press F2.
Although this is specific to your site, the
most common selection is
DNS
. If you
selected DNS, the system displays the
following series of messages to set up the
DNS name service.
21a
Domain name:
Enter the domain name and press F2.