Procedure
1. Screw the mounting screws directly into the wall or ceiling, or using the wall anchors
provided. Install the screws 6 cm apart horizontally, in a space that has 5 cm
clearance above the screws, 2.7 cm clearance to either side and 10 cm clearance
below.
Leave the screw heads about 2 mm out from the mounting surface.
2. Gently remove the adapter cover from the back of the repeater by pushing in and
up on the ribbed section, indicated by an arrow in the following image.
3. Plug the AC adapter connector into the yellow adapter opening, as in the following
image:
4. Without inserting the cover on an angle, carefully replace the adapter cover, and
press on it until you hear it click.
5. Mount the repeater on the mounting screws installed in step 1.
6. Plug the power supply into the nearby outlet and dress the power cable.
For EU models, install the appropriate plug into the repeater power supply
adapter.
7. If the repeater is registered, ensure that the repeater connects properly with the
base station. If it is not registered, see
Overview
D100 SIP Wireless Terminal Installation and Administration Guide
December 2012 51