Handset registration
The following sections explain how to perform DECT registration and de-registration directly
on the D160 handset, as well as de-registration using System Status Application. Note that
registration and de-registration will not affect registered phones or calls in progress.
Prior to registering a handset, ensure that other DECT equipment in the environment has
Registration mode disabled or the equipment could cause a disruption.
Related topics:
on page 43
Registering a handset using the handset
on page 43
De-registering a handset using the handset
on page 44
De-registering a handset using System Status Application
on page 45
Powering the handset
Insert the D160 battery into the handset to begin handset operation.
• Use only the D160–compatible battery.
• Fully charge the battery before use.
• When the battery no longer holds a charge, dispose of the battery responsibly.
Registering a handset using the handset
You can register a D160 handset using the following procedure.
Before you begin
Ensure that your device is not connected to a base station. The handset display should read
Not Registered
or
Searching
. If at any time the registration process fails, the handset display
reads
Registration Failed
and the device returns to an Unregistered or Searching state.
Procedure
1. While the handset is in an Unregistered or Searching state, press the
Regist
soft
key.
The handset display flashes a message that reads
Press Reg. Key On Base
.
• If the handset is in a Searching state, the handset is attempting to find a new base
station. Press the
Regist
soft key followed by the
OK
soft key to continue with
the registration procedure.
Overview
D100 SIP Wireless Terminal Installation and Administration Guide
December 2012 43
