Mounting repeaters
You can mount the repeater on a wall or ceiling. Determine the following when choosing a
location to mount the repeater:
• A location that is higher than cubicle wall height provides better coverage.
• The repeater power supply cord is 2 metres (78 in) long, so you should mount the repeater
within 2 metres (78 in) of an outlet.
Beware of metal surfaces or concrete thickness greater than 3 feet (1 meter) that might cause
signal interference.
Note that a repeater must be no closer than 35 feet (10 meters) from the base station or another
repeater on the same base station. Also, the repeater must be no closer than 17 feet (5 meters)
from other DECT equipment.
Before you begin
Ensure that you have the necessary screwdriver to use with the two mounting screws supplied
with the repeater.
Refer to the following diagram to determine the required mounting space for the repeater, which
is 15 cm (6 in) by 11.4 cm (4.5 in).
Hardware preparation and installation
50 D100 SIP Wireless Terminal Installation and Administration Guide
December 2012