PARTNER Version Quick Installation Guide
Page 18
- Issue 1b (09 April 2010)
IP Office Essential Edition
2.2 IP500 Card Installation
The IP500 base cards and trunk daughter cards should be fitted before power
is applied to the control unit. Ensure that cards are inserted in the order that
matches the planned or pre-built configuration.
1.
Fitting IP500 Trunk Daughter Cards to the Base Cards.
2.
Installing IP500 Cards into the Control Unit.
Refer to
System Capacity/Planning Rules
for any recommendations and
restrictions on where particular cards can be installed.
·
Correct anti-static protection steps should be taken before handling circuit boards.
·
Cards must never be added or removed from the control unit while it is switched on.
2.2.1 IP500 Daughter Card Preparation
IP500 trunk daughter cards can be fitted to any IP500 base card. For IP500 Combination cards, the trunk daughter card is
pre-installed and cannot be changed.
·
Correct anti-static protection steps should be taken while
handling circuit boards.
Parts and Equipment Required
1.
o
IP500 Base Card
2.
o
IP500 Trunk Daughter Card
3.
o
3 Stand Off Pillars
These are supplied with the trunk daughter card.
Tools Required.
1.
o
5mm Flat-blade screwdriver.
2.
o
Anti-static wrist strap and ground point.
Procedure: Installing an IP500 Trunk Daughter Card
1. Check that correct cards have been supplied.
2. Ensure that you are wearing an anti-static wrist strap connected
to a suitable ground point.
3. On the base card identify the position of 3 holes for the plastic
pillars for the IP500 card. These are along the same edge as the
card connector.
4. Fit the stand off pillars to the IP500 base card.
5. If there is a clip-on metal shield over the connector block on the
base card, remove it.
6. Using minimal force and checking that the pins are correctly
located, push the IP500 trunk card onto its connector block and
the stand off pillars.
7. Check that the card connector has snapped into position.
8. Using the washers and screws provided, secure the metal stand
off pillars to the base card.
9. A set of labels are supplied with the trunk daughter card. Fit the
appropriate label to the front of the base card.
18
19
14
Summary of Contents for IP Office Essential Edition PARTNER Version
Page 1: ... Issue 1b 09 April 2010 PARTNER Version Quick Installation Guide IP Office Essential Edition ...
Page 4: ......
Page 6: ......
Page 26: ......