Page 16 - Functional Ground
Preparing for Installation
Functional Ground
The IP Small Office Edition Office functional grounding is as follows:
Caution:
This functional ground is
not
a protective ground.
To connect the functional ground:
1. Use a 3.5mm Jack Plug (not supplied with kit) fitted with a suitable length of #14
AWG (minimum) solid insulated cable. The sleeve
must not be
green/yellow.
2. Insert this Jack Plug into the Functional Ground Jack Socket.
3. Connect, using a fastening that satisfies local regulations, the other end of the #14
AWG wire to the approved ground, such as building steel or an earthed metal cold
water pipe.
Page 16 - Preparing for Installation
IP Office - Small Office Edition Installation Manual
Functional Ground
40DHB0002UKED – Issue 2 (29th July 2004