IP Office Basic Edition - Quick Mode Installation
Page 45
15-601042 Issue 24i (20 December 2011)
IP Office 8.0
Installation Requirements: Space Requirements
2.2.4 Rack Space Requirements
All IP Office control units and external expansion modules can be rack mounted into standard 19" rack systems. Each unit
requires a 2U slot space within the rack. Rack mounting requires an IP400 or IP500 rack mounting kit for each control unit
and external expansion module.
Where IP Office systems are being rack mounted, the effect of conditions within the rack cabinet must be considered. For
example the rack temperature may be above the room temperature and airflow within the rack will be restricted. The
environmental requirements
for the individual IP Office units are still applicable inside the rack cabinet.
Note that the new IP500 Wall Mounting Kit V2 can also be used for rack mounting of units.
IP500 Rack Mounting Kit
·
IP500 Rack Mounting Kit (SAP 700429202)
This kit contains all the components required for the rack mounting of
a single IP500 V2 control unit, IP500 control unit or IP500 external
expansion module. This includes screws for fixing of the brackets to
the module, bolts for securing the module in the rack and cable tidy
brackets.
IP400 Rack Mounting Kit
·
IP400 Rack Mounting Kit (SAP 700210800)
This kit contains all the components required for the rack mounting of
a single control unit or expansion module. This includes screws for
fixing of the brackets to the module and bolts for securing the module
in the rack.
Barrier Box Rack Mounting Kit
·
Barrier Box Rack Mounting Kit (SAP 700293905)
Barrier boxes must be used for
out-of-building analog phone
extensions
. This bracket allows up to 8 IP Office barrier boxes to
be rack mounted and simplifies the number of connections to the
protective ground point in the rack. This kit must be used when more
than 3 barrier boxes are in use and supports a maximum of 16
barrier boxes for a single external expansion module.
40
28
