Deploying Avaya IP Office™ Platform IP500 V2
Page 176
15-601042 Issue 30j (18 May 2015)
IP Office™ Platform 9.1
Comments on this document? infodev@avaya.com
12.13.2 Example 2: Video Conference
In this example, calls are routed to a Polycom Viewstation module connected to a S0 port of the IP Office system.
The following settings were used on 4 incoming data channels of a PRI line:
·
Line Number: 5
·
Channel Allocation: 23 -> 1
·
Switch Type: 5ESS
·
Line Sub Type: PRI
·
Provider: AT&T
·
Channels: 1-4
·
Incoming Line Group: 95
·
Outgoing Line Group: 95
·
Direction: Bothway
·
Bearer: Data
·
Service: Accunet (this is a important)
·
Admin: In Service
To route an incoming video call on the PRI lines configured above to an SO8 module requires the following:
1. Create a dial short code that has the SO port as its destination Line Group. For this example the following was used:
· Short Code: 1500
· Number: .
· Feature: Dial
· Line Group: 601 (the SO8 port number)
2. Create an Incoming Call Routing that routes the appropriate calls to that short code. For this example the following was
used:
· Line Group: 95 (identifies calls using the PRI lines configured above)
· Destination: 1500 (the short code created above)
· Bearer: Any
To allow the video device on the S0 port to make outgoing calls to the PRI lines also requires a short code.
1. For this example the following was used:
·
Code: 91N;
·
Number: N
·
Feature: Dial
·
Line Group: 95
