Upgrade Firmware on Programmable Circuit Packs
Self and C-LAN-distributed download Procedure
SI Installation and Upgrades
729
June 2004
NOTE:
In most cases, the image with the more recent date and time stamp is the new firmware
image file.
4
Type
set boot-image board
UUCSS
image
1 | 2
and press Enter.
Example: set boot-image board 1C07 image 2
The system responds with
Command Successfully Completed
.
5
Type
get boot-image
UUCSS
and press Enter to check the status of the firmware images on the
target circuit pack.
Note that the values in the
Reboot Image
field has changed.
NOTE:
If a TN799C/DP C-LAN or TN2501 VAL circuit pack, reseat them to activate the new
firmware image. Go to
Reseat VAL circuit pack
on page 726.
6
Type
get boot-image
UUCSS
to check the status of the firmware images on the target circuit
pack.
7
Ensure that both the
Active Image
and the
Reboot Image
fields are as you expect.
get boot-image 1C07
DISPLAY FIRMWARE IMAGE(S)
Image 1 Image 2
Board Type: TN2501 TN2501
FW Vintage: 02 01
HW Signature: 02 02
Suffix: A A
Date: 09/13/02 05/06/02
Timestamp: 10:30:50 12:42:18
CRC Checksum: Good Good
Active Image: Yes No
Reboot Image: No Yes
get boot-image 1C07
DISPLAY FIRMWARE IMAGE(S)
Image 1 Image 2
Board Type: TN2501 TN2501
FW Vintage: 02 01
HW Signature: 02 02
Suffix: A A
Date: 09/13/02 05/06/02
Timestamp: 10:30:50 12:42:18
CRC Checksum: Good Good
Active Image: No Yes
Reboot Image: No Yes
