Installing the Hardware
Step 4: Configuring the Fax Boards
Octel 50 Installation Guide
3-7
The following figure displays recommended jumper settings for the 432 board. The first
column lists the board number, the second column lists the port address that should be
assigned to each board, and the third column represents the jumper settings that
correspond to the port address.
The following figure displays recommended jumper settings for the 4132 and 4108
boards. The first column lists the board number, the second column lists the port address
that should be assigned to each board, and the third column represents the jumper
settings that correspond to the port address.
Step 4:
Configuring the Fax Boards
Fax boards allow the Octel 50 system to use the Fax Solution features. You must
configure the fax boards for use with the Octel 50 system before you install them.
Fax boards contain ports, which are the interface between the fax board and a phone
system channel. The Octel 50 system supports a maximum of 12 fax channels.
Octel 50 supports the Brooktrout TR112 fax board.
The boards you install in the Octel 50 PC must be purchased from an authorized
representative so they are programmed with the proper signature.
