Administering Telephone Options
78 Avaya one-X™ Deskphone Value Edition 1600 Series IP Telephones Administrator Guide Release 1.0
Interface Control
Use the following procedure to set or change the interface control value.
1. While the telephone is on-hook and idle, press the following sequence of keys on the
faceplate of the telephone:
Mute 4 6 8 # (Mute I N T #)
Note:
Note:
Press the
Mute
button momentarily. Do not press this button while pressing other
keys/buttons.
2. After entry of the command sequence, telephones with an internal Ethernet switch display
the following text, depending on the current interface control value:
where
status
is the value of PHY1STAT, defined as:
●
Status is
auto
when PHY1STAT = 1
●
Status is
10Mbps HDX
when PHY1STAT = 2
●
Status is
10Mbps FDX
when PHY1STAT = 3
●
Status is
100Mbps HDX
when PHY1STAT = 4
●
Status is
100Mbps FDX
when PHY1STAT = 5
3. To change the PHY1 value, press
*
.
Depending on the current value, the next sequential valid PHY1 value is selected and
displayed as the status. For example, if the current value is 10Mbps HDX (2), pressing
*
changes the value to 3 (10Mbps FDX).
4. Press the
*
button to terminate the procedure, or the # button to save the new value. If you
press the
#
button, the following text displays:
where
status
is the value of PHY2STAT, defined as:
●
Status is
disabled
when PHY2STAT = 0
●
Status is
auto
when PHY2STAT = 1
●
Status is
10Mbps HDX
when PHY2STAT = 2
●
Status is
10Mbps FDX
when PHY2STAT = 3
●
Status is
100Mbps HDX
when PHY2STAT = 4
PHY1=
status
*=change #=OK
PHY2=
status
*=change #=OK
