Migrating a G350 LSP to a G700 LSP (Communication Manager 2.1 or later)
64 Converting an Avaya S8300 Media Server Between ICC and LSP Modes
On the gateway’s MGP
16. Access the G700’s
console port and set up
the G700 IP addresses
and the gateway’s
controller list.
Start on page 533.
●
Assign IP addresses to the gateway components.
●
Enter the IP addresses of the primary controller
and up to three alternate controllers.
●
Set the G700 LSP transition points.
●
Reset MGP
On the LSP’s primary controller
17. Verify that the media
gateway has registered
with the primary
controller.
●
Open a SAT session and enter
list
media-gateway
. Verify that the Registered field
(Reg?) is set to
y
.
●
Place a test call.
On the LSP
18. Set time, date, and time
zone.
Page 259.
The time of the LSP must be set to the same time zone as
its primary controller, even if the LSP is physically located
in a different time zone.
19. Install post-conversion
service pack file, if any.
Page 260.
Skip the Verify Media Server Configuration section
starting on page 247.
20. Install the G700 LSP
license file.
Starting on page 262.
21. Install the authentication
file.
Starting on page 264.
22. Configure server.
Starting on page 464,
ending on page 478.
●
Fill in each Configure Server screen with data for
the LSP.
●
On the Configure Local Survivable Processor
screen, select one of the three LSP choices
depending on the primary controller type.
23. Reboot the LSP.
Open a SAT session and enter
reset system 4.
After the reboot, the LSP should be registered with the
primary controller and in a few minutes translations
should be synchronized.
Task
Steps/Comments
