ATM Tips
Issue 1 May 2002
4-53
555-233-143
In this example the errors that have
ATM-NTWK
for
Name
and
1
for
Data
indicate an error returned to the TN230X from the ATM network. In this
case,
Type
indicates the cause code returned by the ATM network (see
). In the previous example, two cause codes (41
and 3) are reported from the ATM network. For more information about
these cause codes and repair information see
ATM Call Control
Are ATM signaling connections being setup to A500 Call Control?
Enter show switch circuit table on the A500 console.
shows the
screen output.
Table 4-6.
Observed Cause Codes
Cause
Code
Definition
Observed Cause
3
No route to destination
The ATM addresses administered in the ATM switch
(show signaling routes or show signaling esi) or in
S8700 Multi-Connect (display atm pnc) are incorrect.
31
Normal, unspecified
This is a normal return.
41
Temporary failure
This “try again later” cause code has been observed
when the source of the problem is on another port (for
example, a routing problem on another port that
displays cause code 3).
47
Resources unavailable,
unspecified
S8700 Multi-Connect call volume is too high for the
available resources in the ATM network.
63
Service or option unavailable,
unspecified
S8700 Multi-Connect call volume is too high for the
available resources in the ATM network.
Summary of Contents for S8700 Series
