Maintenance-Object Repair Procedures
555-233-143
8-850
Issue 1 May 2002
119
FAIL
The SNI circuit pack (Endpoint 1) cannot communicate with the equipped SNI
in slot 19. (The list fiber-link command displays a fiber link’s endpoints.)
1. Perform the
‘‘Fault Isolation for Fiber Links’’ on page 4-19
. This should
resolve multiple SNI-PEER errors.
2. If the SNI being tested has SNI-PEER Error Type 3585, replace the SNI
being tested. (Replacing an SNI may be service interrupting. Refer to the
SNI-BD section for the procedure to replace an SNI.) To view SNI-PEER
errors, use the display errors command with category PNC-PEER. Retry
the command.
3. If the SNI being tested still has SNI-PEER Error Type 3585, replace the
SNI in slot 19.
120
FAIL
The SNI circuit pack (Endpoint 1) cannot communicate with the equipped SNI
in slot 20. (The list fiber-link command displays a fiber link’s endpoints.)
1. Perform the
‘‘Fault Isolation for Fiber Links’’ on page 4-19
. This should
resolve multiple SNI-PEER errors.
2. If the SNI being tested has SNI-PEER Error Type 3841, replace the SNI
being tested. (Replacing an SNI may be service interrupting. Refer to the
SNI-BD section for the procedure to replace an SNI.) To view SNI-PEER
errors, use the display errors command with category PNC-PEER. Retry
the command.
3. If the SNI being tested still has SNI-PEER Error Type 3841, replace the
SNI in slot 20.
133
FAIL
No neighbor link is assigned, but the SNI (Endpoint 1) has an EI neighbor.
(The list fiber-link command displays a fiber link’s endpoints.)
1. Administer the SNI on a fiber link to the EI neighbor it is connected to via
the add fiber-link next command. Or remove both fiber endpoints (i.e.,
this SNI and its EI neighbor) and remove the fiber endpoints from circuit
pack administration via change circuit-pack.
134
FAIL
No neighbor link is assigned, but the SNI (Endpoint 1) has an SNI neighbor.
(The list fiber-link command displays a fiber link’s endpoints.)
1. Administer the SNI on a fiber link to the SNI neighbor it is connected to via
the add fiber-link next command. Or remove both fiber endpoints (i.e.,
this SNI and its SNI neighbor) and remove the fiber endpoints from circuit
pack administration via change circuit-pack.
135
FAIL
The SNI circuit pack (Endpoint 1) cannot communicate with its assigned
neighbor. (The list fiber-link command displays a fiber link’s endpoints.)
1. Check if the administered neighbor is inserted. If not, insert the neighbor
circuit pack.
2. Perform the
‘‘Fault Isolation for Fiber Links’’ on page 4-19
.
Table 8-328.
Test #759 Configuration Audit —
Continued
Error
Code
Test
Result
Description / Recommendation
Continued on next page
Summary of Contents for S8700 Series
