Maintenance Commands
555-233-143
7-74
Issue 1 May 2002
change system-parameters
ipserver-interface
This is the change system-parameters command with the ipserver-interface
parameter.
This command displays the subnet address of the two servers and allows the user
to administer the switch identifier and turn on/off IPSI control of port networks.
NOTE:
You must run this command before running add ipserver-interface.
Output (for IP Connect)
change system-parameters ipserver-interface Page 1 of 1
IP SERVER INTERFACE (IPSI) SYSTEM PARAMETERS
SERVER INFORMATION
IPSI Host Name Prefix:
Primary Control Subnet Address: 198.152.254. 0
Secondary Control Subnet Address: 198.152.255. 0
OPTIONS
Switch Identifier: A
IPSI Control of Port Networks: enabled
Summary of Contents for S8700 Series
