Maintenance Commands
555-233-143
7-370
Issue 1 May 2002
status pnc
status pnc [print]
NOTE:
This command is not valid for S8700 IP Connect configurations.
The status pnc command displays a summary of conditions on the active and
standby Port Network Connectivities (PNC). If the PNC is not duplicated, the
screen displays blanks in the PNC-B and other duplication-related fields.
Output
The following display shows a typical result when
status pnc is entered on a
system with a single switch node CSS and duplicated PNC.
The output shows a new
Inter PN Index
field. For switches with CSS PNC,
the index contains 6 fields, and for switches with ATM PNC, the index contains 4
fields. The new fields represent the BFDL fault classes.
status pnc
PORT NETWORK CONNECTIVITY
Duplicated? no
Software Locked?
Standby Busied?
Direct Connect? no
Standby Refreshed?
Interchange Disabled?
A-PNC B-PNC
Mode: active Mode:
State of Health: State of Health:
Inter PN Index: Inter PN Index:
Inter SN Index: Inter SN Index:
Major Alarms: 0 Major Alarms:
Minor Alarms: 0 Minor Alarms:
Warning Alarms: 0 Warning Alarms:
SN Locations: 01E SN Locations:
Summary of Contents for S8700 Series
