LA85 Port Tester
Issue 1 May 2002
4-17
555-233-143
The port tester is equipped to check 110-type wall field hardware with the three
1-pair patch cords that are color-coded blue (1), orange (2), or green (3).
NOTE:
If the wall field has 66-type blocks, a 66-type block adapter
(Comcode 405546474) is needed.
!
DANGER:
The port tester should not be plugged into an active circuit for an extended
period of time. Resistors in the tester can burn out.
LED indications for the various port types are listed in
Abbreviations are as follows:
■
R = Red
■
G = Green
■
N = Not lighted
■
N/A = Not applicable
Intermediate closet
wall field
Isolate part of the wiring
span (either to the switch or
to the terminal)
Table 4-1.
Port fault isolation using the LA85 Port Tester —
Continued
To begin the isolation
procedure at the
You may need this
preliminary
information or
equipment And
if
Then
Continued on next page
Summary of Contents for S8700 Series
