Reducing the chassis weight
Reduce the chassis weight to make the chassis easier to lift, and to reduce the risk of personal
injury or equipment damage.
Remove the filler modules from the front and rear of the chassis.
Remove the two cooling modules from the front of the chassis.
About this task
Important:
Do not install additional components before you mount the chassis in the rack.
All unused slots must contain filler modules. If you remove filler modules to reduce the chassis
weight, ensure you reinstall them after you complete the chassis installation.
Procedure
1. To unseat the filler module, loosen the two captive screws, grasp the two handles, and
gently pull the module out and away from the chassis.
Virtual Services Platform 9010 chassis
October 2015
Installing the Avaya VSP 9000
32