3
Insert the Module
L
You should upgrade the P330 switch firmware and Embedded Web Manager to version
3.12 or higher before installing the X330W-2USP module.
To insert an X330W-2USP into an Avaya P330 switch:
1
Remove the blanking plate or installed expansion module.
2
Insert the WAN expansion module gently into the slot, ensuring that the Printed Circuit
Board (PCB) is aligned with the guide rails.
L
The PCB fits into the guide rails and not the metal base plate.
3
Press in the expansion module firmly until it is completely inserted into the Avaya P330
switch.
4
Gently tighten the two screws on the front panel of the expansion module by turning them
clockwise.
5
Power up the Avaya P330 switch.
X
The self-test procedure starts. It takes between 30 to 60 seconds to complete.
X
The OPR LED on the X330W-2USP module should illuminate 55 seconds after startup.
The module is then ready for use.
L
You can now safely connect the cables to the unit.
