4
Connect the Ports
Connecting the Universal Serial Ports
In order to connect a USP module to the network use one of the following options:
•
V.35 – use the Avaya Serial Cable DTE V.35 (catalog number: 700247588)
•
X.21 – use the Avaya Serial Cable DTE X.21 (catalog number: 700247596)
L
Note: The X330W-2USP module functions as DTE.
Connecting the FastEthernet Port
A UTP Category 5 cable must be connected to the 100Base-TX port, via an RJ45 connector. The
maximum UTP cable length connected to the 10/100 Mbps port operating as 10/100BASE-T
is 100 m (328 ft.).
L
You can obtain appropriate cables from your local supplier.
L
If you are connecting the FastEthernet port to a PC or workstation, you should use a
crossed cable.
L
If you are connecting the FastEthernet port to another switch, you should use a straight
cable.
Connecting the Console Port
Each Avaya X330W-2USP module has one serial port on the front panel for connecting a
terminal, a terminal emulator, or a modem. The serial port on the front panel is labeled
“Console” and has an RJ-45 socket.
1
Insert the RJ-45 plug on the console cable into the Console port of the Avaya X330W-2USP
module.
2
Insert the other end into the RJ-45 socket in the supplied DB-9 adapter.
3
Insert the DB-9 plug into the serial (COM) port on the PC or terminal.
L
To connect a modem, use the cable and an RJ-45 to DB-25 adapter.
L
The cable and two adapters can be found in the Avaya P330 accessory set supplied with
P330 switches, and they are clearly marked.
