Engineer’s Checklist
page 36
CHECKLIST
Initial diagnostic road test
Wheel bearings wear and lubricate
Wheel alignment of the 3 front wheels
Steering and tilting mechanism
Wear or damage to tyres or wheels
Tyre pressures
Bodywork fixtures
Throttle movement, play and adjustment
Bodywork
Steering bearing for wear
Seat mounting
Transaxle mountings are tight
Handlebar alignment
Motor brush wear
Motor speed check
Transaxle play
Electromagnetic brake operation
Freewheel operation
Frame for damage or cracks
General corrosion
All operational controls work correctly
Battery condition and charger operation
Tighten all nuts & bolts
Check tie rod bolts
Final road test
Clean vehicle
Customer road test
Flash codes for controller
1 flash
Battery needs recharging
2 flashes Battery voltage too low
3 flashes
Battery voltage too high
4 flashes Current time limit out
5 flashes Brake fault or Freewheel engaged
6 flashes Accelerator lever pulled in when ignition switched on
7 flashes Speed pot error
8 flashes Motor volt error
9 flashes Other internal error