Avdel 07500, Instruction Manual

ENVIRONMENT

WASTE DISPOSAL: Through authorised contractor to a
licensed site. May be incinerated.
Used product may be sent for reclamation.
SPILLAGE: Prevent entry into drains, sewers and water courses.
Soak up with absorbent material.

HANDLING

Wear eye protection, impervious gloves (e.g. of PVC) and a
plastic apron. Use in well ventilated area.

STORAGE

No special precautions.

PROPERTIES

RESULT

Foaming tendency/stability

ml @ 24

°

C

Trace/Nil

ml @ 93.5

°

C

20/Nil

ml @ 24

°

C after test @ 93.5

°

C

Trace/Nil

Air release value minutes to

0.2% air content @ 50

°

C

4

Seal compatibility index

10

Water separation time

in minutes to 40-40-0 @54

°

C

15

@83

°

C

15

18

Priming is ALWAYS necessary after the tool has been dismantled and prior to operating. It may also be necessary to restore the full
stroke after considerable use, when the stroke may be reduced and fasteners are not fully placed by one operation of the trigger.

O I L   D E T A I L S

The recommended oil for priming is Hyspin VG32 available in 0.5l (part number 07992-00002) or one gallon containers (part number
07992-00006). Please find specific table and safety data below.

P

 R I M I N G

FIRST AID

SKIN: Wash thoroughly with soap and water as soon as
possible. Casual contact requires no immediate attention.
Short term contact requires no immediate attention.
INGESTION: Seek medical attention immediately.
DO NOT induce vomiting.
EYES: Irrigate immediately with water for several minutes.
Although NOT a primary irritant, minor irritation may occur
following contact.

FIRE

Suitable extinguishing media: CO2, dry powder, foam or
water fog. DO NOT use water jets.

PROPERTIES

RESULT

ISO oil type

HL

ISO viscosity grade

32

Kinematic viscosity

cS @ 40

°

C

32

@ 100

°

C

5.3

Relative density

at 20

°

C

0.875

Viscosity Index

95

Pour point

°

C

-  30

Open Flash point

°

C

232

Neutralisation value mg KOH/g

1.5

H Y S P I N   V G   32   O I L    

S A F E T Y   D A T A

P R O C E D U R E

Item 

numbers in bold

 refer to the general assembly and parts list pages 16 and 17.

I M P O R T A N T

DO NOT OPERATE THE TRIGGER WHILE THE BLEED SCREW IS REMOVED.

All operations should be carried out on a clean bench, with clean hands in a clean area.

Ensure that the priming pump is free from foreign matter

and that the oil is perfectly clean and free from air bubbles.

Care MUST be taken at all times, to ensure that no foreign matter enters the tool, or serious damage may result.

After dismantling the tool, it is necessary to prime the tool in the following manner.

Hold the trigger in and disconnect the tool from the air supply.
Remove the rear bleed screw and washer (item 

84

 and 

85

 page 16).

Offer priming pump to priming nipple and pump until non-aereated oil issues from the rear bleed hole. Replace and tighten rear
bleed screw 

84

.

■

■

■