8
Nose Assemblies
Fitting Instructions
It is essential that the correct nose assembly is fitted prior to operating the tool. By knowing the details of the fastener to be placed, you will be
able to order a new complete nose assembly using the selection tables on pages 7.
I M P O R T A N T
The air supply must be disconnected when fitting or removing nose assemblies unless specifically instructed otherwise.
Nose assemblies must be pre-assembled before fitting.
STRAIGHT HORIZONTAL, VERTICAL OR ROUND NOSE ASSEMBLIES
•
Lightly coat the jaws with Moly Lithium grease.
•
Assemble Spring Guides
4
and Spring
5
•
Balance the three Chuck Jaws
3
on the upper Spring guide
4
(using a spent pintail to aid positioning if
necessary)
•
Carefully lower Chuck Collect
2
over the assembled components
•
Insert Spacer
6
(if required) into Chuck Collet 2 (5/16” dia only)
•
Assembly can then be located in anvil
Item numbers in
bold
refer to the drawing opposite.
Accessories
Collar Splitters
You can order collar splitters to cut the collars off placed Avdelok
®.
The small size shown below left is for cutting 3/16” and 1/4” collars. The larger
size shown below right is for 5/16” and 3/8” collars.
Dimensions shown in bold are millimetres. Other dimensions are in inches