28
F a u l t D i a g n o s i s
S Y M P T O M
P O S S I B L E C A U S E
R E M E D Y
PA G E R E F
More than one
Air leak
Tighten joints or replace components
-
operation of the
Insufficient air pressure
Adjust air pressure to within specification
5
trigger needed to
Lack of lubrication
Lubricate tool at air inlet point
7 and 16
place fastener
Worn or broken jaws
Fit new jaws
8-10*
Low oil level or air present in oil
Prime tool
26-27
Build up of dirt inside nose assembly
Service and lubricate nose assembly
9†
Tool will not grip
Worn or broken jaws
Fit new jaws
8-10*
stem of fastener
Build up of dirt inside nose assembly
Service and lubricate nose assembly
8-10*
Loose jaw housing
Tighten against locking ring
8-10*
Weak or broken spring in nose assembly
Fit new spring
8-10*
Incorrect component in nose assembly
Identify and replace
8-10*
Rotary valve incorrectly adjusted
Adjust as in ‘Operating Procedure’
7
Jaws will not
Build up of dirt inside nose assembly
Service and lubricate nose assembly
9†
release broken
Jaw housing, nose tip or nose casing
Tighten nose assembly
9
stem of fastener
not properly seated
Weak or broken spring in nose assembly
Fit new spring
8-10*
Air or oil leak
Tighten joints or replace components
-
Low oil level or air present in oil
Prime tool
26-27
Cannot feed
Broken stems jammed inside tool
Empty stem collector
4 (point 14)
next fastener
Check jaw spreader is correct
8-10*
Adjust air pressure to within specification
5
Rotary valve incorrectly adjusted
Adjust as in ‘Operating Procedure’
7
Slow cycle
Lack of lubrication
Lubricate tool at air inlet point
7
Low air pressure
Adjust air pressure to within specification
5
Build up of dirt inside nose assembly
Service and lubricate nose assembly
9†
Tool fails to operate
No air pressure
Connect and adjust to within specification
5
Damaged trigger valve
40
Replace
22-23
Restricted air supply
Check for restrictions such as kinked
22-23
pneumatic pipe
Loose stem collector
Tighten retaining nut
26
22-23
Fastener fails to
Insufficient air pressure
Adjust air pressure to within specification
5
break
Fastener outside tool capability
Use more powerful Genesis tool.
5
Contact Avdel
Low oil level or air present in oil
Prime tool
26-27
* Pages 12 to 13 if a swivel head is used instead of a nose assembly.
† Page 13 if a swivel head is used instead of a nose assembly.
Item numbers in
bold
refer to the general assembly drawings and parts lists pages 22-25.
Other symptoms or failures should be reported to your local Avdel authorised distributor or repair centre.
Summary of Contents for Genesis G2-s
