- 36 -
G
Function 3: setting, display and modification of the USER CODE
Note 3: The code programmed at the factory is 0000.
It is possible to change and enter the user code by means of the above-mentioned procedure.
If the user looses or forgets his own code, he should proceed as follows:
• Cut the mains voltage and disconnect the back-up battery and the GSM battery.
• Connect the mains voltage, the back-up battery or the GSM battery again.
The device now allows the user to enter the programming with the factory code (0000)
within a period of 30 s. and to modify the previously programmed code.
Warning
If this operation is not performed within 30 sec., the dialler returns to the condition in
which it accepts only the previously programmed user code.
FUNZIONI
FUNZIONI
Programming of FUNCTIONS
Entering FUNCTION 3: setting, display and
modification of the USER CODE
COD UT
COD UT
_
_
_
_
_
_
_
_
_
_
_
_
_
_
_
_
3
✓
✗
Display of the USER CODE
previously programmed for confirmation
(see note 3)
To change it, keystroke the new USER CODE
(min. 4 figures)
1 2 3 4
1 2 3 4
✗
✓
✓
✗
Confirmation of
the programmed USER CODE by
and exit from the function by
or time-out
✓
✗
C.415 10-06-2002 9:11 Pagina 36
