- 45 -
G
Function 9: Block of the operating cycle from the keypad.
By selecting this function, it is possible to stop the dialler, during the calling operating cycle,
by pressing any key from the keypad.
Jumper JP1 must be positioned on the INST position to enter this function.
Note 7:
• To enable this function choose Y, by pressing key
• To disable this function choose N, by pressing key
FUNZIONI
FUNZIONI
Programming of FUNCTIONS
Programming of the keypad block
(see note 7)
Function 9 entering: block of the operating cycle
in progress by pressing any key from the key-
pad.
BL
BL
Tast
Tast
tast
tast
y
y
9
✓
✓
✗
*
#
✗
Confirmation of the
programmed number through
and exit from the programming through
or time-out.
✓
C.415 10-06-2002 9:11 Pagina 45