- 11 -
Make sure that the keypad is in programming mode
leds ON in a continuous sequence (yellow,
red+green, yellow, …). If this is not the case, repeat
the different steps of phase 1 and insert the master
code previously stored.
The three LEDS are ON in sequence (yellow,
red+green, yellow, …) to signal the program-
ming mode in progress.
Keep the green key pressed until when two
confirmation beeps are heard
Insert the 4 figures of the user code to be
stored.
Press the green key until when a
confirmation beep is heard (followed by
another two consecutive beeps)
Make sure that the three leds switch off.
Every time a key is pressed, a confirmation
beep will be heard. As soon as 4 figures are
inserted, the three LEDs of the keypad will
start flashing.
If the code has already been stored, 5 short
beeps will be heard.
Further codes can be inserted (up to 7) by
repeating the last three steps.
Note: upon trying to insert the eighth code, 5
short beeps will be heard.
The keypad exits from the programming mode automatically.
Note. This programming must be repeated on each keypad of the
system; the user codes may differ on each keypad.
PHASE 3
The keypad remains in stand-by for 30
seconds waiting for further user codes to
be inserted.
Make sure that the keypad is in programming mode
(leds on in a continuous sequence (yellow,
red+green, yellow, …). If this is not the case, repeat
the different steps of phase 1 and insert the master
code previously stored.
The three LEDS are ON in sequence (yellow,
red+green, yellow, …) to signal the program-
ming mode in progress.
Keep the
red key pressed until when two confir-
mation beeps are heard.
Insert up to 12 numbers max. representing the 12
bits of the keypad code (corresponding to the 12
rubber pads of key AF45339, see fig.2).
After confirming the last number of the keypad code,
press the red key until two confirmation beeps are
heard.
Make sure that the three leds switch off.
Every number must be confirmed with the red
key (confirmation beep).
Note: if the system is provided with AF45342
readers, the keypad code to be programmed
must correspond to the one set on key
AF45339 (the numbers to be inserted are the
ones not covered by rubber pads. In the exam-
ple of figure 2: 2, 4, 6, 8, 10), otherwise insert
twelve figures
The keypad code has been inserted.
The three LEDS switch on in sequence (yellow,
red+green, yellow, …) to signal the program-
ming mode in progress.
This programming must be repeated for each
keypad of the system.
The keypad exits from the programming mode
automatically, after 30 seconds from the last
pressure of any key.
PHASE 2
The keypad remains in programming mode for 30
seconds awaiting further instructions.
C421 14-10-2005 14:50 Pagina 11
