- 12 -
Keypad code deletion
The
keypad code
previously stored can be deleted according to the instructions
listed below:
User code deletion
The
user code
previously stored can be deleted according to the instructions listed
below:
Set the keypad to programming mode by repeating
the steps of phase 1 and inserting the master code
previously stored.
The three LEDS are ON in a continuous sequence
(yellow, red+green, yellow, …) to signal the pro-
gramming mode in progress.
Keep the red key pressed until when two
confirmation beeps are heard.
Keep the red and green keys pressed at the same
time until when three short beeps followed by a long
confirmation beep are heard.
Keep the red key pressed until when two
confirmation beeps are heard.
Make sure that the three leds switch off.
Deletion control of the keypad code.
The three LEDS switch on in sequence (yellow,
red+green, yellow, …) to signal the program-
ming mode in progress.
Note: Now a new code can be stored in the con-
trol unit by repeating the procedure described in
phase 2 by disconnecting the control unit for a
few seconds in order to delete the previously sto-
red code also from the control unit itself.
The keypad exits from the programming mode automatically,
after 30 seconds from the last pressure of any key.
The keypad remains in programming mode for 30
seconds awaiting further instructions.
Set the keypad to programming mode by repeating
the steps of phase 1 and inserting the master code
previously stored.
The three LEDS are ON in a continuous sequence
(yellow, red+green, yellow, …) to signal the pro-
gramming mode in progress.
Keep the green key pressed until when two
confirmation beeps are heard.
Insert the 4 figures of the user code to be
deleted.
Keep the red and green keys pressed at the
same time until when three short beeps
followed by a long beep confirming that the
code has been deleted, are heard.
Make sure that the three leds switch off.
Every time a key is pressed, a confirmation beep
will be heard. Upon inserting the fourth figure, the
three LEDs of the keypad will start flashing.
If the code inserted is not already included in the
keypad storage, 5 short beeps will be heard.
Now, the three LEDs are OFF and further user
codes can be deleted by inserting the four figures
as per the step mentioned above.
The three LEDS switch ON in sequence (yellow,
red+green, yellow, …) to signal the programming
mode in progress.
Note: Now new user codes can be stored accor-
ding to the previously described procedure.
The keypad exits from the programming mode automatically, after
30 seconds from the last pressure of any key.
Keep the green key pressed until when two
confirmation beeps are heard.
The keypad remains in programming mode for 30
seconds awaiting further instructions.
C421 14-10-2005 14:50 Pagina 12
