Avem Quirks
National Service Support Line:
1800 658 120
1
Getting Started
If the vaccine cabinet was shipped to you, please wait at least three hours prior to turning it
on. This will allow the oil in the compressor time to settle after shipping.
Avem Quirks Medisafe refrigerators are powered by electric current, which can cause
serious injury. Any installation, cleaning, or troubleshooting must be conducted with the electrical
power source disconnected from the unit.
The following precautions should be taken while the unit is in operation:
Ensure the appropriate power is supplied to the unit. Note: Avem Quirks Medisafe units are
designed to operate at 220-240V, 50Hz.
Do not plug several appliances into the same multiple receptacle
Electrical components should not come into contact with water
Ensure the power cord is not damaged. If the cord becomes damaged, it must be replaced by
the manufacturer, a certified service agent or qualified service professional.
It is strongly recommended that any servicing of the unit be performed by Avem Quirks
Australia.
Installation
Place the Medisafe refrigerator in a location with a flat surface that is approximately level, with
reasonable clearance from any walls, and without exposure to direct sunlight.
Allow clearance to the right, left, back and top. This will reduce power consumption and allow
the internal cooling system to function correctly. The unit is not to be placed in confined areas
where air flow and heat dissipation are restricted.
Ensure that the appropriate power is supplied to the unit. Note: Avem Quirks Medisafe
refrigerators are designed to operate at 220-240V, 50Hz. National and local codes provide
specific electrical and mechanical installation requirements and recommendations covering
equipment and equipment wiring.
Plug in and turn on the power to the Medisafe refrigerator. Ensure the power point is secure,
that the refrigerator cannot be accidentally unplugged or switched off.
When the power is first turned on, the Min-Max temperature display will show an alert “PF”
flashing on the display. This informs the operator there has been a loss of power, and can be
acknowledged by pressing the red “set” button on the Min-Max display.
Basic Operation
The power failure alert “PF” should be acknowledged by pressing the red “
set
” button on the
Min-Max temperature display.
The Medisafe refrigerator is pre-set for operation. No buttons on the controller are to be touched
except the red “
set/mute
” button, used to silence the audible alarm.
It is recommended to run the Medisafe refrigerator for 6 hours prior to loading with
vaccines.
