5
INSTALLING AND REMOVING WHEELS
Place the wheel hub on the axle by simply pushing in the wheel until it snaps in place, so the wheel can
not be removed. Push in all the way so that the wheel cannot be pushed further. After both wheels
are assembled/attached, pull on the wheels to ensure they cannot be removed. To remove the wheels,
lift back of trailer up and simply push on the push buttons located on the axle and remove the wheel.
NOTE: Check tire sidewall for proper tires inflation & check tires regularly.
WARNING
Failure to properly install and adjust wheels with quick release levers could allow wheel to
come off during use. This could lead to serious injury.
AT TA C H IN G R E F L E C T O R O R L E D L IG H T
(O P T IO N A L )
To screw the red reflector or clip the LED light on the loop at rear of trailer and the spoke reflector on
both sides of wheels.
Make sure to install the reflectors or led light for your safety.
FLAG
Insert the flagpole into the flagpole loop at the left rear corner of the side panel.
Make sure to always use the safety flag to maximize your visibility to other vehicles
sharing the road or path .
