NOTICE: Do not perform any of the steps in the Operation section of this manual until you have read
this entire manual, since there are important details related to safety in the following sections.
20
GETTING STARTED
Press and hold the “M” button on the handlebar controls to turn on the
“M” for 3 seconds.
assist, simply start pedaling, then tap the “U” or “D” arrows to increase
or decrease the amount of pedal assist. Pedal assist will engage at
speeds up to 20 MPH.
SINCH
The SINCH E-Bike is equipped with a throttle, which is mounted near
the rider’s left thumb, to propel the bike without pedaling. With throttle
on demand, you can throttle the bike from a complete stop up to
20mph while in PAS 1 through 5. However, we strongly encourage you
to pedal first and throttle second.
OPERATION
The motor stops when you: stop pedaling, squeeze the brake levers,
or release the throttle. Simply start pedaling again to re-engage the
motor.
BATTERY AND CHARGING
W
temperature conditions. To charge the battery, plug the charger into
the charging port and then connect the charger to a wall outlet. The
LED indicator light will be red when charging and will turn green when
charging is complete.
MAINTENANCE AND SERVICE
Properly maintaining your Sinch E-Bike ensures its longevity and
smooth operation. Before assembling your bike, please watch the
“How To Assemble” video we’ve prepared for you. If you have
questions during the assembly process, please contact Aventon at
(866) 300-3311 or visiting
https://support.aventon.com/contact-us
.
.
SAFETY
You should wear an approved bicycle helmet every time you ride
a bicycle, regardless of the legal requirement to do so. You should
comply with local law when riding your Sinch E-Bike.
Read and understand all sections of this entire manual before operating the bike for the first
time. There are important safety warnings throughout the manual that must be followed
to prevent dangerous situations, accidents, damage to the bike, damage to property, injury,
or death.
Users must follow the instructions and warnings contained in this manual for safety. Do not
attempt to operate your bike from Aventon Bikes until you have adequate knowledge of
its control and operation. Damage caused by failing to follow instructions is not covered
under warranty and could result in serious injury or death. Contact Aventon Bikes if you have
any questions about assembly or operation.
Users must become accustomed to the bike’s power control system before operating. The
pedal assistance feature is also a powerful option and users should fully research and
understand how to operate it before first use. Not taking the time and care to familiarize
yourself and practice the operation of the power system on your bike from Aventon Bikes can
lead to damage, serious injury, or death.
Derailleur
On the right side of handlebar, next to the brake lever, you can see two levers
with 7-1 gears. Those are derailleur levers. By pressing those levers, you can
make the chain move to different gears to change your riding experience
.
