www.avenview.com
Page
7
7.2
INPUT PANEL (
HBT-C6POE-VGA-S
) Back Panel
1.
POWER LED:
This LED will illuminate when the
device
is connected to an active power supply.
2.
DC 24V:
Connect the 24 V DC power supply to the
unit and plug the adaptor into an AC outlet. Only one
unit requires powering if both the Transmitter and
Receiver are both PoE compatible.
3.
RS-232 IN:
Connect to a PC or RS-232 control system
with a D-Sub 9 pin male cable for the transmission of
RS-232 commands.
4.
LAN:
Connect to an active network for LAN serving.
When any compatible LAN equipped receivers are
connected, this allows the network access (including
internet access if available) to be shared between any
connected LAN equipped receivers. Connect any
Ethernet equipped device e.g. a Smart TV or games
console to the LAN port of a receiver for that device
to share the network/internet access.
2
3
4
5
6
7
1
5
.
IR Blaster:
Connect the supplied IR Blaster cable for IR
signal transmission. Place the IR Blaster in direct line-of-
sight of the equipment to be controlled.
6
.
IR Extender:
Connect the supplied IR Receiver cables
for IR signal reception. Ensure that remote being used is
within the direct lineof-sight of the IR Extender.
7
.
CAT5e/6/7 OUT:
Connect to the Receiver unit with a single CAT5e/6/7 cable for transmission of all data signals.
MODE LED: This LED will illuminate when the power is connected.
LINK LED: This LED will illuminate when connected to a Receiver unit
that is connected with a TV/monitor that is displaying the signal.
pANEl DESCRIpTION
