Avenview HDM-C6IP4K Overview
The Avenview HDM-C6IP4K-SET features a chipset that enables extension, switching and compositing of
real-time, uncompressed Ultra-HD AV signals with zero-frame latency over off-the-shelf (OTS) Layer 2/
Layer 3 Ethernet switches In addition of that, it also can extend 8 channels of audio, 1 Gb Ethernet, 480
Mbit/sec USB 2.0
1
and other control signals over either multi or single mode fiber or Cat-X cabling.
Avenview HDM-C6IP4K-SET Evaluation Kit
The Avenview HDM-C6IP4K-SET Evaluation/Demo Kit that you have received consists of the
following hardware and software components:
2x Transmitters (TX):
Transmitters are meant to be connected to source devices such as
computers, laptops, Blu-ray players and other media or HDMI source devices. The I/O interface is
as follows:
o HDMI-input
o Audio-input
o IR input and output
o RS-232 (bidirectional)
o RJ45 Ethernet Port (10/100/1000)
o 10 GbE Fiber or Copper output for connection to a 10 GbE Ethernet switch or direct to
a BlueRiver NT Receiver (RX) in case of point to point setup.
2x Receivers (RX):
Receivers connected to display devices such as LCD/LED displays
and projectors. The receivers have the following I/O:
o HDMI-output
o Audio-output
o IR input and output
o RS-232 (bidirectional)
o RJ45 Ethernet Port (10/100/1000)
o 10 GbE Fiber or Copper input from 10 GbE switch or directly from a BlueRiver
NT transmitter in case of point to point setup.
4x SFP+ transceivers only if received BRNT devices are for fiber extension
4x Power Supply Units
BlueRiver Manager
: Control demo software to configure and control extension and routing of all
signal types between
HDM-C6IP4K
TX and RX devices. For operation, The BlueRiver
1
Requires 3
rd
party USB 2.0 chipset
INTRODUCTION
www.avenview.com
Page 5
www.avenview.com
Page
1
Manager software has to be installed onto a Windows 7 or Windows 8.1
/10
computer/laptop
that is connected directly to the 10 GbE switch or directly to the RJ45 Ethernet port on one of the
TX or RD devices.
