Method A: IR Remote Control
Button
Function
POWER
Power On/Off the video wall processor
AUDIO +
Increase Audio Volume
AUDIO -
Decrease Audio Volume
Fast switch to Full Screen 1x1
Fast switch to VW3x1 (+90°)
Fast switch to VW3x1 (-90°)
Fast switch to VW2x2
Fast switch to VW4x1 (+90°)
Fast switch to VW4x1 (-90°)
PREVIOUS
Recall previous rotation setting
MUTE
Mute the RCA Stereo jacks
MENU
Call OSD menu and confirm
Factory Reset
Factory default reset
OPERATION
5.
Page|1
2
www.av
enview.com
(
HDM2-PROWALL-T4K )
NOTE:
IR remote controls use infrared light to control TVs, and this unit players and other electronic
devices. When an infrared remote control is not working, or is working intermittently, the cause might
be interference.
Ambient Light
Ambient light, especially sunlight, can overload or desensitize the sensor on the electronic device and
cause it to miss signals sent from the remote control. Devices that use infrared to communicate with
the remote control should be shielded from bright, direct light.
Other Remotes
If you use several infrared remote controls at once, they can interfere with each other by scrambling
the IR codes that are being sent to the device. Separate your infrared receiving devices to avoid this
interference.
Fluorescent Lamps with Electronic Ballasts
Electronic ballasts regulate power supplies in newer fluorescent lamps and bulbs. These ballasts can
modulate high frequency light coming from the lamp or bulb and confuse the receiving device