Page|15
www.avenview.com
Press CH-1/CH-2 button to select input port. Default input port is HDMI 2.0-1.
For one content edge blending display (all-in-one), user can select any input source in one
EdgePro application.
If multiple EdgePros are cascaded for edge blending, user needs to select HDMI-1 input source
and cascade to next unit through loop out port for big scale edge blending. If user wants to
select other signal sources for multiple unit cascade, user needs to add video distributor (or
splitter) in signal source and feeds the same signal to all EdgePro.
User needs to select source for CH-1 first, it will apply to both channels. Then select source for
CH-2 if CH-2 requires different source content.
If user wants to display independent content in each projector, user can select any two input
sources among HDMI, DP and VGA. User can’t select two HDMI input sources for independent
display in two projectors due to system limitation.
In multiple unit cascade system, user still can implement independent content display in each
projector through the selection of the input port for each output channel.
The output resolution selection will apply to both output channels at the same time. Default
output resolution for all channels is 1080p.
The output resolution should be the same as the projector native resolution to get the best
video quality. If user changes output resolution, geometry result will also be changed.
User can select output resolution through remote controller, USB or Ethernet.
Output resolution list: 720x480, XGA, WXGA, 1280x1024, 1366x768 ,1400x1050, 1600x1200,
1920x1080 (24/30/50/60Hz), 2048x1080/60 & 1920*1200/60
。
All output default resolution is
60Hz, RGB 4:4:4 and progressive. User can select 1080p 50 Hz to avoid frame repeat issue if the
input is 50Hz.
User can set EDID to have input source provide desired resolution. However, input resolution
is subjected to signal source and may not output desired resolution.
EdgePro can support non-VESA standard input timing once signal source can provide, such as
4096x2160, 3200x2400.
When press [OTH] key to select output resolution from remote controller, the monitor will
show the timing and take few seconds to finish the selection.
User can click [Info] key to get system information and see input / output signal resolution.
6.3.1
Input source selection
6.3.2
Output resolution selection
