Page|34
www.avenview.com
Familiarize yourself with OSD operation from remote controller, including activating grid
pattern, CH-1/CH-2 switching and hot keys for [Corner], [Warp], [Video Wall], [Edge Blend]
and [Info].
[OSD Time Out] is default to ”0”. It will ensure the grid pattern will not be turned off
automatically. Input mode change will disable OSD and grid pattern.
User can install IR extender receiver near each projector for easy EdgePro operation. If
multiple units of EdgePro are used and IR receivers are put together, please set [Box ID] for
each EdgePro so that user can control each EdgePro separately through [85x] command. Press
number keys in Remote Controller following OSD menu for the control of multiple EdgePro:
•
850: will activate all EdgePro. User can execute simultaneous control for all EdgePro
•
851: activate only ID #1 EdgePro for further control.
•
852: activate only ID#2 EdgePro for further control.
Each channel should execute geometry, video wall setting and edge blending setting
separately.
Use [Pattern] & [CH-1/CH-2] selection keys to show grid patterns in all projectors. Press
[Pattern] key again will change grid color. To set two different pattern colors in adjacent
projectors will be more convenient during geometry alignment.
If user finds the grid size between adjacent projectors is different. Some possibilities:
o
The projection image sizes between two projectors are different (Zoom setting or
projection distance is different).
o
Output resolution settings in different EdgePro are not the same.
o
Projector aspect ratio setting is different or not set at full screen display.
o
EdgePro
is set at [Original AR] under the menu of [Image Properties]→ [Scaling] menu.
If user doesn’t use Excel file to calculate the image size in each projector, please try to set the
same projection height prior to geometry adjustment. In this case, the image width and
overlap grid size for all projectors will be also similar and is ready for further geometry
alignment.
8.3.1
Geometry alignment through remote controller
8.3.2
Activate Grid Pattern
