92
5.9.7
To Setup SMS/MMS Setting:
To use this feature, GSM/GPRS modem is required. Connect the GSM/GPRS modem to the
serial COMM port of PC. Beside the SMS/MMS check box, click
Detail
.
i
MMS module is developed by ActiveXperts Software B.V.
1. Select the port number in
ComPort
drop down list from where the GSM/GPRS modem is
connected.
2. Click
Modem Setup
button to automatically detect the Modem Baud Rate.
3. In
Local Phone Number
text box, enter the GSM SIM card phone number.
4. In
Phone Num
text box, enter the contact number.
5. You may now set to send thru SMS &/or MMS. If you enable SMS setting, just enter the
message in the text box. If you enable MMS, enter the APN name, WAP IP, MMS address
and the message. If you are not sure, please contact your mobile service provider.
6.
Attach image when sensor is triggered
select the camera that the images will be
capture and send when the sensor is triggered.
7. Click
OK
to accept the new settings and
Cancel
to exit without saving.
i
Make sure your ISP provider and cell phone provider both support JPG file format
transmitting.
5.9.8
To Setup PTZ Preset Point:
Beside the PTZ preset point check box, click
Detail
. In
the Trigger PTZ Preset Setting dialog box, select the
PTZ camera number then select the Enable check box.
Select the position of the PTZ camera when the alarm
is activated and ended. For the PTZ camera ended
point, user also can select one preset position or
Auto
Path
between preset position group.
