3.5. Screen programming.
Picture 11 Screen with built-in triggered
control system electric installation
8
Screen
bl - blue (common)
br - brown (live)
yg - yellow-green (protective)
bk - black (manual control)
Power line
L1 - brown (live)
N - blue (neutral)
G - yellow-green (protective)
bk
br
yg
bl
!!! NOTICE !!!
Do not connect any any electric devices except multimedia projector to the power outlet located at the trigger transmitter.
Maximum projector power consumption 600W.
!!! NOTICE !!!
The screen was programmed properly at the factory and there is no need to reprogram it without any important
reason. Setting of screen extreme positions was made by manufacturer.
If you need to change the screen extreme position follow the instructions described below.
optional wall
switch
WS-
Picture 9 Screen without remote control system
electric installation
Screen
bl - blue (common)
br - brown (rolling down)
yg - yellow-green (protective)
bk - black (rolling up)
Power line
L1 - brown (live)
N - blue (neutral)
G - yellow-green (protective)
bl
yg
bk
br
Programing the length of the rolled out screen (screen bottom bar position).
- Roll up the screen until it will stop automatically in the upper position.
- Insert regulation wrench included in the screen set into the regulation slot (see picture. 6) located in the left bottom
part of the screen .
Regulation knob “2” (bottom) enables setting of the lower extreme position of the screen bottom bar:
„+” - means increasing the lenght of the fabrics is rolled down when the screen is rolled out,
„–” - means decreasing the length of the fabrics is rolled down when the screen is rolled out.
Regulation knob “1” (upper) enables setting of the upper extreme position of the screen bottom bar:
“-“ - means increasing the lenght of the fabrics is rolled down when the screen is rolled in,
“+” - means decreasing the length of the fabrics is rolled down when the screen is rolled in.
~
~
Picture 10 Screen with built-in +RCX control system
electric installation
Screen
bl - blue (common)
br - brown (live)
yg - yellow-green (protective)
Power line
L1 - brown (live)
N - blue (neutral)
G - yellow-green (protective)
bl
yg
br
~
Picture 12 Lower bar fine tuning