38
2. Specify an
Interval
. The Inverted is the duration of time when
the trigger remains in active mode before returning to active
level 0.
To configure the
Digital Output Device:
1. Define the active level and response interval as with the DI
device. The default active level for DO devices is 1, which
means the DO device will respond once triggered.
2. Click
Apply
when you are finished configuring both DI and DO
devices.
Notification messages can be sent to an email or a HTTP server. You
can configure up to three preset messages.
To configure notification messages:
1. Check the
Notification Message
box to enable the message
and then use the
Send Message to
drop-down menu to
determine if sending the message to an email or a HTTP
server.
2. Enter the appropriate information depending on which method
you have chose.
3. Click
Apply.
Your AvertX HD510 camera can send video recording/ snapshots to
your chosen server upon event. If audio is enabled on the device, the
uploaded video will also have audio.
There are a maximum of 10 Event rules which are shown in abbreviated
form in the Event List.
To configure a new event:
1. Click the desired
ID number
.
2. Check the
Enabled
check box.
You can still configure an event even if it is not enabled. The
event configureation will be saved and can be enaled at a later
time.
5. Check the
Active on
check boxes for the desired week days the
event will be active.
6. Use the drop-down menus to chose a time and event duration.
For example, a rule that allows motion detection trigger snapshot
uploads to FTP would only take place after 19:00 each day for a 12 hour
duration. Outside of this duration, this event will not take place.
There are several triggers that can cause events. These triggers
include:
DI:
digital inputs, or external network devices that are connected to the
camera. These include sensors or switches.
Motion:
if the camera senses motion detection.
