ZM305 GTN Inbound-Outbound User Instructions
41
7.1 Setpoint
Follow these steps to set the items in the Supervisor menu.
7.1 Setpoint
Super
Setpoint
1.
Access the Supervisor menu. Refer to
Accessing the menus on page 24
for
instructions. From
SuPEr
, press
SELECT
…
SEtPnt
is displayed. Use this to:
l
set the mode of setpoint operation
l
set the function of the setpoint annunciators
l
enter up to three setpoint values
l
select function for up to three inputs
l
print the setpoint settings
l
reset all setpoint settings to factory defaults.
Annunciators
Setpoint
Edit
Annun
2.
Press
SELECT
…
Edit
is displayed.
3.
Press
SELECT
…
Annun
is displayed.
This stands for annunciators, referring to the
SP1
,
SP2
and
SP3
setpoint
annunciators. By default (
oFF
) these annunciators are ON when the
selected mode of the setpoint is active or OFF when the selected mode
of the setpoint is not active. If you select
on
, the annunciators work in
the opposite fashion--OFF when the selected mode is active or ON
when the selected mode is not active.
The
and
symbols used in this section stand for direction moved in the menu. So
Super
Setpoint, shown above, illustrates that you move down from
SuPEr
to
SEtPnt
. This will help you keep track of where you are in the menu structure.
If you are using a battery operated indicator with any application, setpoint output #3
can be configured for shutting down the battery for power saving. See the Service
manual for information on setting up setpoint outputs and optional power saving
circuitry you can create to shutdown power from a battery.
A setpoint value can be entered ranging from +/- scale capacity. See
Entering a
negative number on page 14
for the negative numeric entry process.
See the Service manual for information on enabling the setpoint outputs. Setpoints
that are not used should be disabled.
